Brand New PanaVise Custom InDash Mount for the 2007-2012 Acura RDX
Model # 75116-807
The Panavise InDash Custom Mount eliminates exposed holes in vehicle for clean, easy, and nearly invisible phone mount installation. Proudly made in the USA from the highest quality heavy gauge steel, this Panavise Custom Indash Mount has been fitted and produced specifically for your car to provide the utmost convenience and practicality. Complete mounting instructions are included with your purchase and are also available below.
Compatible Car:
Mounting Instructions:
Mounting Location: Right Side of Radio
Tools Required: Dash Tool, Hook Tool, Phillips Screwdriver
Hardware Included: (3)A-#8x9/16"Needle Pt. Screw
Step# 01
With hook tool remove the small square bezel to the left of the display. Begin by inserting hook tool into the bottom of the bezel and pull straight out to release (1) clip.
Step# 02
Pull off the end cap to the right of the dash by the passenger door with the vent on it releasing (3) clips. Set cap aside.
Step# 03
Begin to release the long horizontal bezel to the right of the display. There are a total of (6) clips. Remove the (2) exposed Phillips screws to the Right and Left of the display.
Step# 04
Remove the radio and climate controls bezel which includes the air vents by inserting hook tool into a corner below the removed screw. Pull to release (1) clip. Continue to release (4) total other clips on this bezel. Pull bezel out to get at the screws to the lower right/back of the radio cavity. Remove the radio screw, and place the InDash by PanaVise Mount over the screw hole and replace the screws.
Step# 05
Install the (3) supplied screws into the mounting holes. Replace all the bezels in reverse order.
If we don't have it listed please email us.
